← Back to the chapter · Previous detail
Technical detail · Why Hardware Prototyping Matters
Review a wearable BLE beacon
A lithium-polymer (LiPo) cell is a rechargeable battery. Serial Wire Debug (SWD) is a connection used to program and debug the chip. Antenna detuning means the case or nearby parts shift the antenna away from its intended radio response. A brownout is a drop in supply voltage that can cause a reset or faulty operation. Test each of these risks in the actual build.
Choose one operating sequence before measuring: advertise, drive the vibration motor, return to sleep, then recover through the programming connection. Keep current and radio observations aligned with that sequence. A reset during the motor pulse points to a different question from weak reception after the case is fitted, even if both appear as missing advertisements.
A team moves from an nRF52840 development kit to a wearable BLE beacon using an LIS3DH accelerometer, a LiPo cell, a charger IC, SWD programming pads, a vibration motor, and a small enclosure. The prototype question is no longer “can BLE advertising work?” It is whether the physical build can survive charging, firmware updates, antenna detuning, button access, battery brownout, and wearer motion.
The engineering prototype should measure advertising interval, connection current, sleep current, charge current, battery cutoff behavior, enclosure effect on RSSI, accelerometer interrupt behavior, vibration-motor load transients, and firmware recovery through the SWD header. A Nordic Power Profiler Kit II, BLE scanner log, firmware build hash, and assembly notes make the result repeatable enough to decide whether to revise the board, adjust the antenna keep-out, change the enclosure, or build a small pilot batch.