← Back to the chapter · Previous detail · Next detail →

Technical detail · Cellular IoT Power Optimization

Compare three power policies

This comparison shows the calculation method rather than a measured device result. Replace each term with measurements from the actual device.

PolicyUse whenTrade-offMeasure
PSM-only reportTelemetry is uplink-first and downlink can wait for scheduled wake windows.Lowest listening time but delayed commands and maintenance.Energy for wake, registration or resume, send, active window, and return to sleep.
eDRX commandableCommands must arrive within a bounded paging delay.Higher listening energy than PSM, but better commandability.Granted paging cycle, PTW, command delivery delay, and daily listening energy.
Maintenance modeUpdates, diagnostics, or profile changes are scheduled for a short service window.Temporary energy increase, but avoids keeping the device reachable all the time.Update duration, transfer failures, rollback behavior, and post-maintenance sleep recovery.

Example calculation pattern:

normal_day_mAh =
  sleep_state_mAh
  + wake_cycles_per_day * measured_wake_and_send_mAh
  + granted_active_window_mAh
  + expected_retry_mAh
  + host_and_sensor_mAh
  + self_discharge_allowance

maintenance_day_mAh =
  normal_day_mAh
  + update_transfer_mAh
  + diagnostic_session_mAh
  + retry_margin_mAh

Do not average away rare but expensive events. If a firmware update, weak-signal retry storm, or SIM failure drains a large share of the battery, it belongs in the lifetime model.

← Back to the chapter · Previous detail · Next detail →