← Back to the chapter · Previous detail
Technical detail · Cellular IoT Power Optimization
Review network grants and trace markers
12.7 Network-Granted Timer Review
PSM and eDRX are negotiated behaviors. Firmware can request timer values, but the network grants the actual behavior the device must live with. A battery model that records only requested values is not a release-quality model.
The largest energy costs often sit outside the payload itself: cell search, attach or resume, authentication, bearer setup, DNS, TLS, retransmissions, coverage repetitions, paging windows, and delayed release from connected states.
Measure those costs as states, not averages. Mark when the host wakes, when the modem searches, when the SIM becomes ready, when registration succeeds, when the payload starts, when the last acknowledgement returns, and when both modem and host enter the intended low-power state. Without those markers, the same daily average can hide completely different failure modes.
Weak coverage is the usual trap. A device with a tiny payload can spend most of its energy repeating access attempts, holding a bearer open, retrying DNS or TLS, or waiting for release. The release model should therefore include normal coverage, weak installed coverage, outage recovery, server failure, and maintenance-update cases before it predicts fleet lifetime.
Also check tail energy after the useful message has finished. A socket left open, an aggressive keepalive, a debug UART, or a sensor rail that stays powered can erase the savings from a good radio timer. The trace should show the return-to-sleep point for the whole board, not only the modem.