For Kids: Meet the Sensor Squad!

For Kids: Meet the Sensor Squad!

animation
sensors

the microcontroller needed to pick a temperature sensor for a garden weather station. But there were SO many choices! How do you pick?

“Step one: Write down what you NEED,” Max said. He made a list: - Measure -20 to +50 degrees (gardens get cold in winter!) - Accurate to +/- 0.5 degrees - Waterproof (it rains!) - Run on batteries for at least a year - Cost less than $10

Temperature Terry (DS18B20) raised his hand: “A sealed probe made with my chip may resist water, depending on its assembly; the bare chip is not waterproof. I cost $3, I am specified to ±0.5 degree from −10 to +85 degrees, but that accuracy is not specified at −20 degrees, and I sleep at only 1 microamp!”

Dee the DHT22 tried too: “I measure humidity, but my worst-case error at −20 degrees is too large for this requirement. I am also not waterproof.”

The BME280 jumped in: “I measure temperature, humidity, AND pressure! But my temperature accuracy is only +/-1 degree.”

Max made a comparison chart. “No one meets every requirement yet. Let’s test a calibration or find another sensor.”

the battery approved: “With DS18B20’s tiny sleep current, I can last for YEARS! Always check the power consumption before choosing!”

the LED added: “And ALWAYS test the sensor in real conditions before you build 100 of them. What works on your desk might not work in a rainy garden!”

Back to the chapter