Raspberry Pi Output and Camera Tests
Raspberry Pi Output and Camera Tests
An NPTEL Raspberry Pi lesson pairs two small tests. The first uses a Raspberry Pi, LED, 100 ohm resistor, breadboard, and jumper wires to show that software can drive a physical output. The second connects the Raspberry Pi camera module through the board’s dedicated CSI slot and proves that the operating-system interface can reach the sensor. Together they separate wiring, software setup, and captured output. A larger build can blur these three paths.
For the LED path, the source installs the Python development package and python-rpi.gpio, connects the LED’s negative terminal to ground and its positive terminal to an output pin, and edits a Python file with nano. The script selects GPIO.BOARD numbering, configures physical pin 11 as an output, drives it high and low with one- and two-second delays for five loop passes, and calls GPIO.cleanup(). Keep the pin mode, pin number, resistor, polarity, loop count, delays, and cleanup in the record. Saying only “the LED blinked” leaves out what made the test repeatable.
For the camera path, the source places the ribbon cable in the dedicated CSI connector, boots the Pi, enables the camera through raspi-config, and reboots. It then captures image.jpg either with raspistill -o image.jpg or with a picamera.PiCamera() object and capture('image.jpg'). Preserve which path was used, the configuration step, the output filename, and the resulting file. These commands come from the source lesson. A current lab should record the actual image, package, command, and interface it used. Tools may have changed since the lesson.
The GPIO test crosses the library, pin mode, circuit, and timing. The camera test crosses the connector, setup, capture command, and output file. Find the first step with no evidence. Check polarity and pin numbers before changing the blink loop. Make one image file before debugging image processing.