I2C Scanner
I2C Scanner
NoteOptional I2C Scanner Checklist
Use an I2C scanner when a board powers up but a sensor library cannot find its device.
| Step | What you check | Expected evidence |
|---|---|---|
| 1. Power and ground | Sensor VCC and GND match the controller voltage | Sensor board powers on; no hot components |
| 2. Bus wiring | SDA to SDA, SCL to SCL, shared ground | Scanner can probe the bus without lockup |
| 3. Pull-ups | SDA and SCL have pull-ups to the correct voltage | Lines idle HIGH on a meter or oscilloscope |
| 4. Address scan | Probe addresses from 0x08 to 0x77 |
Known devices appear at their documented addresses |
| 5. Conflict check | Compare detected addresses against the design | Duplicate addresses are resolved with address pins or a mux |
Example scan result:
| Detected address | Likely device | What to do next |
|---|---|---|
0x3C |
OLED display | Use the OLED library with address 0x3C. |
0x76 |
BME280/BMP280 | Use the sensor library with address 0x76. |
| No addresses | Wiring, pull-up, or power problem | Check SDA/SCL order, VCC, ground, and pull-up resistors. |
Hands-On Lab: I2C Scanner
Objective: Find all I2C devices connected to your ESP32/Arduino.
NoteOptional Scanner Lab Workflow
| Stage | Student action | Evidence to record |
|---|---|---|
| Baseline | Scan with no external sensor attached | No unexpected addresses, or only built-in board devices. |
| Add display | Connect SSD1306 OLED | New address appears at 0x3C or 0x3D. |
| Add sensor | Connect BME280/BMP280 | New address appears at 0x76 or 0x77. |
| Conflict test | Add a second device with the same address if available | Scanner still shows one address, but both devices may respond at once. |
| Fix | Change address pin or use an I2C multiplexer | Each device becomes uniquely selectable. |
Sample scan interpretation:
| Scanner output | Meaning | Next action |
|---|---|---|
0x3C, 0x76 |
OLED and BME280 are both visible | Start the sensor/display application. |
Only 0x3C |
Sensor not responding | Check BME280 power, SDA/SCL order, and address pin. |
| No addresses | Bus-level fault | Check pull-ups, ground, VCC, and whether SDA/SCL are swapped. |