Find the First Device Holding the Shared Bus
Find the First Device Holding the Shared Bus
Find the First Device Holding the Shared Bus
Picture three sensors sharing two wires until adding a fourth makes every reading stop. A microcontroller means a small computer on one chip that starts transfers and controls the device.
Name each address, pull-up, wire length, bus voltage, clock rate, and expected reply. Test one sensor, all sensors, a duplicate address, and a device holding a line low.
Keep the wiring, settings, address scan, signal edges, acknowledgements, and failure time. This proves one local bus setup, not every board layout; the deeper sections explain transfers, electrical limits, timing, arbitration, and recovery.
I2C is useful because one controller can talk to many nearby devices using only SDA and SCL. The shared bus works only when addresses, pull-ups, capacitance, timing, and acknowledgements all stay inside the design limits.