Try It Yourself / Design a Load Switching Circuit
Try It Yourself / Design a Load Switching Circuit
animation
electronics
Try It Yourself
After the quizzes, turn the rules back into a circuit. This relay exercise checks whether you can choose the part, size the resistor, and place the diode without copying blindly.
Challenge: Design a Load Switching Circuit
Objective: Select proper transistor, calculate component values, and draw complete circuit for microcontroller-controlled relay.
Specification:
- Relay coil: 5V, 50mA nominal, 100Ω coil resistance
- Microcontroller: Arduino Uno (5V GPIO; check the operating drive limits, not just the absolute maximum)
- Requirement: Simple, low-cost circuit
Steps:
- Choose transistor type: BJT vs MOSFET? (50mA suggests a small BJT may be suitable)
- Calculate current: check the 50mA coil and turn-off transient against the selected part
- Calculate base resistor for BJT OR gate resistor for MOSFET
- Add flyback diode protection (inductive load!)
- Draw complete circuit with all component values
Solution:
| Item | Selection | Reason |
|---|---|---|
| Transistor | Candidate NPN BJT | Select an exact manufacturer part and check its saturation, current, pinout, and thermal limits at 50mA |
| Base resistor | About 560Ω from a 5V Arduino pin to the selected BJT base, after checking the pin’s source-current rating | Gives about 7.7mA base current for the 50mA coil, a forced gain near 6.5; 4.7kΩ provides only 0.91mA and does not guarantee saturation |
| Flyback diode | 1N4007 across relay coil | Cathode/stripe to +5V, anode to transistor collector |
Wiring map:
| Arduino / Component Node | Connects To |
|---|---|
| Arduino Pin 9 | About 560Ω resistor, then selected BJT base |
| BJT collector | Relay coil negative side |
| Relay coil positive side | +5V supply |
| BJT emitter | GND |
| 1N4007 diode | Across the relay coil, stripe/cathode to +5V |
Expected Observation: Relay clicks ON when GPIO HIGH, OFF when LOW; the nominal base current is about 7.7mA with 560Ω. A MOSFET alternative needs a guaranteed on-resistance at the actual gate voltage and a suitable pull-down and driver.