Interactive Component Calculators

Interactive Component Calculators

animation
electronics
Try Begin with Supply voltage (V) at 3.3, LED forward voltage (V) at 2.0 and Desired LED current (mA) at 10. Change the current and compare the exact resistance with the nearest E12 value.
Observe The LED defaults give 130.0 ohms exactly and a 120-ohm E12 choice, producing 10.83 mA. The separate divider starts at 3.311 V and the RC section at 1.000 ms.
Explain Supply voltage (V) minus LED forward voltage (V), divided by desired current in amps, gives the exact resistor; current and resistor power are then recalculated using the nearest E12 value.

Technical boundaries. Each calculator assumes ideal components and an unloaded divider. They use the resistor ratio for divider voltage, R times C for the time constant and its reciprocal divided by two pi for cutoff; component tolerances are absent.

Interactive Component Calculators

Use the sliders below to calculate LED resistor values, voltage divider outputs, and RC time constants in real time.

LED Current-Limiting Resistor Calculator:

Voltage Divider Calculator:

RC Time Constant Calculator:

Component Selection Summary Table:

Scenario Recommended Components Key Specs Notes
Low-current indicator (<20mA) Standard LED + resistor 220Ω-1kΩ, 1/8W Simple and reliable
Medium current load (100mA-1A) NPN transistor (2N2222) Ic=800mA, hFE>100 Add base resistor
High current load (>1A) Logic-level N-MOSFET RDS(on)<0.1Ω, Vgs(th)<2.5V IRF540, IRLZ44N
Inductive load (motor, relay) MOSFET + flyback diode 1N4007 diode Prevents voltage spikes
3.3V from battery (low noise) Linear LDO regulator AMS1117-3.3, 1A max Simple, low noise
3.3 V from battery (efficient) Buck converter TPS62130; check its efficiency curve at the chosen input voltage and load Potentially longer battery life
Sensor signal amplification Low-power op-amp LM358 (general), MCP6002 (rail-to-rail) Single supply compatible
5V↔︎3.3V bidirectional Logic level shifter IC TXS0108E, BSS138 I2C, SPI safe conversion

Pro Tips for Component Selection:

  1. Start with reference designs: Most sensor/module datasheets include recommended circuits
  2. Use standard values: Resistors (E12 series: 10, 12, 15, 18, 22, 27, 33, 39, 47, 56, 68, 82)
  3. Buy assortment kits: Get common values (resistors, capacitors, transistors) for prototyping
  4. Check package availability: Through-hole for breadboarding, SMD for final PCB
  5. Read the datasheet: Absolute maximum ratings, recommended operating conditions, typical circuits

Back to the chapter