BJT Base Resistor Calculator

BJT Base Resistor Calculator

animation
electronics
Try Keep Supply Voltage Vcc (V) at 5 and Load Current Ic (mA) at 70; compare results while adjusting Overdrive Factor (typ. 2x).
Observe With Transistor Beta (hFE) at 100 and overdrive at 2, design base current is 1.400 mA and the nearest standard resistor is 3.3 k ohm.
Explain Load Current Ic (mA) divided by Transistor Beta (hFE) gives minimum base current; the overdrive factor scales it before resistor selection.

Technical boundaries. The calculation assumes a fixed 0.7 V base-emitter drop and chooses the closest resistor from a fixed list spanning 100 to 47000 ohms. It flags base current above 20 mA but does not establish transistor saturation or the actual GPIO drive voltage.

BJT Base Resistor Calculator

This calculator estimates base current from an assumed gain and overdrive factor. Operating gain alone does not guarantee saturation. Check the exact part’s saturation test conditions, base voltage, and the driver’s loaded output before selecting the resistor.

Back to the chapter