Experiment 3: PSM or eDRX

Experiment 3: PSM or eDRX

animation
cellular-iot
ltem
lab

Experiment 3: PSM or eDRX

PSM and eDRX are not “battery life buttons.” They are negotiated behaviors that must fit reachability and energy requirements.

Step 3: Compare a browser energy model with a real current trace

  • In the Energy-Aware Design Quiz below, switch to Budget, press Step, then Reveal; this browser workbench was run here.
  • Its displayed example read 52 uA average current and Result: about 52 uA average. This is the quiz’s teaching model, not an LTE-M current measurement.
  • For your own modem, record the requested PSM or eDRX timers and then read back what the network granted.
  • Measure the whole board through attach, transfer, retry, paging or active time, and sleep; use the measured integral to estimate charge per duty cycle.
  • Reject a mode if the actual downlink delay or whole-board charge fails the application target, even when the browser model looks favorable.

Run it: Use the energy quiz below to reason about the mode trade-off instead of picking from the table alone. Open the Budget and Cycle views and press Play or Step to watch how active, transfer, retry, idle or paging, and sleep time add up across one duty cycle, then use Reveal to check each answer and the Design Rule panel to confirm your logic. Bring that reasoning back to this experiment: decide PSM, eDRX, or always-ready only after the whole measured duty cycle, not the wake interval alone, supports the reachability and energy requirement.

Mode
Observe
Change
Explain
PSM
Device can sleep deeply, but the network cannot reach it until the device wakes or updates.
Increase or decrease wake interval based on reporting and service requirements.
Use when delayed downlink is acceptable and active attach/retry energy is measured.
eDRX
Device checks paging less often, reducing power while preserving periodic reachability.
Adjust paging cycle and window to match the fastest acceptable downlink delay.
Use when the device must be reachable more predictably than a deep PSM-only design.
Always ready
Device is easier to reach, but idle and paging energy can dominate the budget.
Reserve for powered devices or short-lived active windows.
Use when the service need is more important than battery life, or when vehicle power is available.
WarningMeasurement Rule

Do not approve a power mode from configuration alone. Measure boot, registration, payload transfer, retries, idle, paging, host sleep, and modem sleep as one duty cycle.

Back to the chapter