Fault injection testing

Fault injection testing

animation
actuators

Step 3: Validate fail-safe behavior with fault injection testing

Physically test all failure modes:

Test 1: Disconnect power to IoT controller
Expected: Actuator moves to safe state
Pass/Fail: ___

Test 2: Disconnect network (Wi-Fi, Ethernet)
Expected: A separate communication-loss timer or local fallback moves the actuator to its defined safe state; a task watchdog need not expire while firmware is still running.
Pass/Fail: ___

Test 3: Force microcontroller crash (trigger WDT)
Expected: Hardware reset → relay de-energizes → safe state
Pass/Fail: ___

Test 4: Remove relay coil power wire
Expected: Relay de-energizes → safe state
Pass/Fail: ___

Back to the chapter