← Back to the chapter · Previous detail · Next detail →

Technical detail · Choosing a Hardware Platform

Support circuits change the evidence

Secure boot checks firmware before it runs. Signed over-the-air (OTA) updates use a signature to check update authenticity. Fleet provisioning sets up identities and settings for many devices. Inrush current is the brief surge when power first turns on. Low-voltage lockout stops a circuit operating below a safe supply voltage. Boot-mode strapping uses pin levels at startup to choose how a chip boots. An easy setup saves time. It can also hide risks in the final device. USB power, breadboard headers, onboard LEDs, auto-reset circuits, SD cards, desktop Linux images, and shield ecosystems speed learning while hiding the behavior of the final device.

A level shifter translates signals between different voltage levels. Pull resistors hold a pin at a defined level when nothing else drives it. The boot-mode straps described above can also change which startup path the test exercises. These support parts can change results even when the main chip stays the same. A development board may include a USB-to-UART bridge, linear regulator, charger, power LED, level shifter, auto-reset circuit, pull resistors, boot-mode strapping, or solder-jumper defaults that are not present in the final design. Those parts can change idle current, reset timing, ADC noise, radio behavior, and first-power symptoms. The platform review should name which support circuits are part of the evidence and which are merely conveniences.

← Back to the chapter · Previous detail · Next detail →