Technical detail ยท Hardware Components: Power and Load Integration
Portable logger parts and acceptance states
11.7.3 Portable Environment Logger
The logger records temperature, humidity, light, and case openings on a small battery. It also saves data locally. Before wiring, record the supply and signal voltages, pins, current paths, and reset state. Test both the readings and the connections.
Start the controller on a current-limited supply and record idle and active current. Add one sensor at a time. Check rail voltage, bus detection, and readings. Once the bus is stable, add storage and test writes during reset and sleep. Review the current measurements before using a battery. Keep each result with the part and its open risks.
11.7.4 Candidate Components by Role
Choose each part for a specific job, then test its electrical and physical fit.
Controller. Development board with enough digital buses, sleep support, serial logging, and accessible test points.
Temperature and humidity sensor. Digital sensor with documented accuracy, mounting guidance, calibration notes, and environmental limits.
Light sensor. Sensor whose spectral response and placement match the measured light condition rather than only board convenience.
Open-state input. Switch, magnetic contact, or optical method with debounce evidence and predictable reset state.
Storage. Local storage module or memory part with clear write-current, file-integrity, and power-loss behavior.
Power path. Battery, charger or power input, regulator, protection, switch, and test points documented as a small power tree.
11.7.5 Evidence Record
Record the outcome and the condition that could change the decision. A conditional part needs a named limit and a later test.
Accepted. The component meets the requirement, works with the selected interface, survives the power state, and has a recorded bench result.
Conditional. The component works only under a constraint, such as short wiring, external pull-ups, limited update rate, or revised placement.
Rejected. The component fails a requirement, creates electrical risk, lacks enough documentation, or blocks a later layout decision.
Deferred. The component might fit later, but the current prototype does not need its complexity or cannot test it yet.