← Back to the chapter · Next detail →

Technical detail · Low-Power Design: Firmware and Wake Policies

Why sleeping silicon still draws current

At very low duty cycles, silicon leakage sets the floor. MOS transistors do not turn off as ideal switches: subthreshold current falls below the threshold voltage but does not become zero. Raising threshold voltage can reduce off current, but it also reduces available on current and can slow the active work the node needs to finish quickly.

Log drain current versus gate-to-source voltage for a low-VT and a high-VT device. Both curves rise smoothly through a subthreshold region before saturating; neither reaches zero current below its own threshold. The low-VT device saturates earlier and reaches a higher on-current, but also settles at a higher off-current floor. The high-VT device saturates later at a lower off-current floor, but also a lower on-current.
Raising threshold voltage lowers off current and available on current. Neither device reaches zero current below threshold.

Read V_GS as the horizontal control and log(I_DS) as the current scale. The low-V_T device reaches saturation earlier and has higher on current, but its off-current floor is higher too. The high-V_T device saturates later with lower on current and lower off current. Neither curve reaches zero below threshold.

Some chip families, including fully depleted silicon-on-insulator processes, expose forward or reverse body-bias modes to shift threshold voltage after fabrication. Treat this as chip-selection evidence. Record supported bias modes, retained state, sleep current, wake time, active-current penalty, and measured board leakage. Body bias cannot compensate for regulators, pull-ups, sensors, or debug circuits that remain biased.

← Back to the chapter · Next detail →