← Back to the chapter · Previous detail

Technical detail · Low-Power Design: Firmware and Wake Policies

Pull-up leakage through a depowered sensor

A depowered sensor is not a zero-volt short. In this example, its protection diode keeps about 0.6 V, so a 4.7 kOhm pull-up on 3.3 V leaks (3.3−0.6)/4700=0.574(3.3-0.6)/4700=0.574 mA rather than 0.702 mA. Two lines over 60 s waste 68.9 mA-s, about 115 times a 10 microamp processor’s sleep charge. The processor can be asleep while its signal connections continue supplying the sensor.

← Back to the chapter · Previous detail