← Back to the chapter · Previous detail · Next detail →

Technical detail · Sensor Selection: Evidence Before Preference

Mounting, environment, and substitution

Mechanical and environmental coupling matter as much as electrical fit. A humidity sensor behind a poor vent path can lag the room condition. A pressure sensor under enclosure stress can report offset shifts. A motion sensor mounted on a flexible board edge can measure board resonance instead of machine vibration. These are not datasheet mistakes; they are system-design effects that the selection process must catch before release.

Lifecycle and substitution also live under the hood. A production program should record lifecycle status, package options, approved alternates, firmware register differences, calibration changes, and supplier notification requirements. Replacing a sensor later can alter noise, timing, compensation, interrupt polarity, default register states, and package wetting behavior even when the new part uses the same bus and broad measurement category.

← Back to the chapter · Previous detail · Next detail →