Skip to content

Check: Shared-bus wiring and addressing

Knowledge check · self-test

Check: Shared-bus wiring and addressing

Check pull-ups, duplicate addresses, and I2C address bytes.

Back to the chapter →

Check pull-ups, duplicate addresses, and I2C address bytes.

## Packet Pete, Networking and packet-journey domain expertCheckpoint: Shared Bus Basics {.depth-l0} You now know: - I2C gets its pin savings from two shared lines, SDA and SCL, rather than one private wire per peripheral. - Open-drain signalling means devices pull low or release; pull-up resistors create the high level. - That same sharing makes capacitance, pull-up strength, and bus length design constraints. ## Packet Pete, Networking and packet-journey domain expertCheckpoint: Addressed Transactions {.depth-l0} You now know: - A normal 7-bit bus uses usable addresses from 0x08 to 0x77, so duplicate module defaults must be planned before wiring. - Address 0x76 becomes 0xEC for the write phase and 0xED for the read phase because the direction bit is part of the first bus byte. - A register read is a two-phase exchange: write the register pointer, issue repeated START, then read the returned data before STOP.

Back to I2C: Transactions and Bus Design: Give Each Responder a Distinct Address