Skip to content

Check: PCB fabrication and bring-up

Knowledge check · self-test

Check: PCB fabrication and bring-up

Decide what to investigate when a new PCB hits its supply current limit and its 3.3 V rail fails to rise.

Back to the chapter →

Decide what to investigate when a new PCB hits its supply current limit and its 3.3 V rail fails to rise.

A team exports Gerbers for a battery node with an SHT31 sensor, SX1262 LoRa module, buck regulator, SWD pads, and JST battery connector. The DRC passes. The board outline fits the enclosure. Name two checks still required before ordering. Strong answers include connector polarity, pin-one marks, antenna keep-out, sensor airflow, regulator hot-loop area, decoupling placement, drill alignment, paste layer, BOM manufacturer part number, pick-and-place rotation, test-point reach, and whether the SWD pads remain accessible inside the enclosure.

Back to PCB Design and Fabrication: Use Failures to Choose the Next Revision