SPI bits narrated tour
SPI bits narrated tour
Technical boundaries. The embedded model assumes ideal digital timing and uses a slowed playback clock. It displays one byte even when frame-time arithmetic uses sixteen bits; tour beats without a supported visual change retain the existing frame and provide captions.
SPI bits narrated tour
SPI selects one peripheral with its chip-select line, then the controller supplies a clock so both devices know when bits are valid. MOSI carries data toward the peripheral and MISO carries data back; keeping these two paths and their timing straight makes a transfer easier to follow.
Narrated audio tour. The full transcript is below.
Play the tour to open the simulator. Pause, replay a beat, or read the full transcript below.
Some beats explain situations this teaching model cannot show; those beats keep the existing frame and provide captions only.
Full transcript — SPI bits (8 beats)
B1 — Sensor exchange
You are bringing a room sensor into service for an Internet of Things project. Your job is to get its reading into a small controller and keep a failed exchange from passing as a valid reading. Start with the conversation that carries those bits.
Model caption: You are connecting a room sensor to a controller. Keep the reading and a failed exchange distinguishable.
B2 — Full duplex
Serial Peripheral Interface, or SPI, is a clocked wired link between a controller and a peripheral, such as your sensor. It uses four signal lines. Two carry data in opposite directions. Full duplex means the controller can send data while receiving data at the same time.
Model caption: Serial Peripheral Interface, SPI, uses four signal lines. Full duplex means sending and receiving at the same time.
B3 — Clock and chip select
The other two lines are the clock and chip select. The controller generates the clock. Chip select becomes low to activate the sensor for the exchange. Selection identifies the participant; clocking provides the timing. The outgoing and incoming data use their own separate paths while the sensor is selected.
Model caption: The controller supplies the clock. Low chip select activates the sensor; separate data paths carry outgoing and incoming bits.
B4 — Sampling edges
A clock edge is a change between low and high. Sampling means reading a bit at the chosen edge. In the animation's mode zero, the clock rests low, sampling happens when it rises, and data changes when it falls. The mode determines which edge is used for sampling.
Model caption: A clock edge changes between low and high. Sampling reads a bit. Mode zero rests low, samples rising, and changes data falling.
B5 — Four microseconds
For a worked sensor example, use mode zero and an eight bit frame at two megahertz: two million clock cycles per second. The model calculates frame time by dividing bits by clock rate. Eight bits divided by two million cycles per second gives four microseconds, or four millionths of a second, for that frame.
Model caption: Eight bits divided by two million cycles per second gives four microseconds, or four millionths of a second.
B6 — Eight bits each way
With the most significant bit sent first, the example begins with the controller sending one while receiving zero. At the next bit position, it sends zero while receiving one. Each clock carries one bit in each direction. Eight clocks therefore move eight bits each way during the same four microseconds.
Model caption: Most significant bit first: b7 sends one and receives zero; b6 sends zero and receives one. Eight clocks move eight bits each way in four microseconds.
B7 — Mode mismatch
The misconception is that matching the clock rate is enough. Keep two megahertz but change the controller to mode one. The model's sensor expects mode zero. The controller now samples on falling edges instead of rising edges, so data may be sampled at the wrong moment despite the unchanged rate.
Model caption: The rate is still two megahertz. The sensor expects mode zero, but mode one samples falling instead of rising. Matching rate alone is insufficient.
B8 — Matched modes
With the sensor selected and clock modes matched, every clock carries one bit each way.
Model caption: With the sensor selected and clock modes matched, every clock carries one bit each way.