LoRaWAN Spreading Factor Workbench and narrated tour

LoRaWAN Spreading Factor Workbench and narrated tour

LoRaWAN spreading factor narrated tour

Play silently with captions on provisional storyboard timing; narration audio is pending. Production pacing is not protocol time. Choose Reduced motion for a complete still at each beat.

Play the tour to open the workbench. Pause, replay a beat, or read the full transcript below. Some situations cannot be shown by this teaching model; those beats keep the existing frame and provide captions only.

Full transcript — LoRaWAN spreading factor (8 beats)

B1 — Field sensor tradeoff
You are the engineer choosing radio settings for two hundred field sensors. A short message barely reaches the receiver. Making that message easier to hear could help, but longer transmissions cost energy and shared channel time. How much extra time does a higher spreading factor cost?

Model caption: Your task: choose radio settings for 200 field sensors. Weak-signal reception competes with energy and shared channel time.

B2 — Chirps and symbols
The radio carries symbols using chirps, controlled sweeps across a span of frequencies. Bandwidth names that span. Spreading factor controls how long each symbol lasts. Longer symbols can help a receiver recover a weak signal, while keeping the channel occupied for longer.

Model caption: A chirp sweeps across a frequency span. Bandwidth is that span; spreading factor controls symbol duration.

B3 — SF7 calculation
For your sensors, hold bandwidth at one hundred twenty-five kilohertz. Start with spreading factor seven. Two raised to the seventh power gives one hundred twenty-eight. Divide one hundred twenty-eight by one hundred twenty-five thousand to get zero point zero zero one zero two four seconds per symbol.

Model caption: 125 kHz = 125,000 Hz. Two to the seventh power = 128; 128 ÷ 125,000 = 0.001024 seconds per symbol.

B4 — Change to SF12
In milliseconds, that is one point zero two four per symbol. Keep the same bandwidth and change to spreading factor twelve. Two raised to the twelfth power gives four thousand ninety-six. Divide four thousand ninety-six by one hundred twenty-five thousand to get zero point zero three two seven six eight seconds.

Model caption: SF7: 1.024 ms. SF12 at the same bandwidth: two to the twelfth power = 4,096; 4,096 ÷ 125,000 = 0.032768 seconds = 32.768 ms.

B5 — Thirty-twofold symbol time
That is thirty-two point seven six eight milliseconds per symbol. Divide thirty-two point seven six eight by one point zero two four: each symbol now takes thirty-two times as long. The bandwidth stayed fixed; changing the spreading factor stretched the time needed for a symbol.

Model caption: 32.768 ÷ 1.024 = 32. Each symbol takes 32 times as long at SF12 as at SF7, with bandwidth fixed at 125 kHz.

B6 — Whole packet airtime
A whole packet also carries overhead alongside its payload, so symbol time is only part of its airtime. Longer symbols lengthen the packet's time on air. For your sensor fleet, more time per message means less shared capacity. The weak signal benefit comes with a channel cost.

Model caption: Symbol duration is part of packet airtime. Payload and overhead also contribute. Longer packets use more shared channel time.

B7 — Link margin tradeoff
The misconception is that the highest spreading factor is always the safest choice for every sensor. It can help weak links, but the extra airtime uses shared capacity. Link margin means breathing room for receiving a weak signal; gaining that room has a time cost.

Model caption: Highest spreading factor for every sensor is not automatically safest: weak-signal breathing room costs shared airtime.

B8 — Shared capacity
Choose spreading factor to give a weak signal enough breathing room while leaving shared channel time for the fleet.

Model caption: Choose spreading factor to give a weak signal enough breathing room while leaving shared channel time for the fleet.

Back to the chapter