Try It: SPI Mode Timing Visualizer

Try It: SPI Mode Timing Visualizer

animation
sensors
Try Keep Data byte (hex) as A5 and SPI Mode on Mode 0, then select Mode 1 to compare sampling markers.
Observe Mode 0 shows clock idle LOW, rising-edge sampling and MOSI bits 10100101; the same byte remains visible as SPI Mode changes.
Explain SPI Mode determines CPOL and CPHA; together they choose rising or falling sampling, with shifting assigned to the opposite edge.

Technical boundaries. The display assumes eight bits drawn most significant bit first at fixed visual spacing; it has no clock-rate or device-delay model. Unparseable hex falls back to A5, while parsed values supply their low eight bits without a byte-range validation check.

Try It: SPI Mode Timing Visualizer

Use clock edges and data timing to see where the receiver samples a bit.

Note

Select an SPI mode and see how CPOL and CPHA affect the clock signal and data sampling edges. Understanding which clock edge is used for sampling helps you debug corrupted sensor readings.

Back to the chapter