RC Filter Calculator

RC Filter Calculator

animation
sensors
Try Set Resistance R (Ω) to 10000 and Capacitance C (nF) to 100, then increase capacitance while comparing cutoff and settling time.
Observe The default pair yields a 1.00 ms time constant, 159.15 Hz cutoff and 5.00 ms settling; the 60 Hz line says the cutoff is too high.
Explain Resistance R (Ω) times capacitance gives the time constant; cutoff is its reciprocal divided by two pi, and settling is five time constants.

Technical boundaries. The calculation assumes a single ideal RC stage without loading or component tolerances. Its 60 Hz message switches when cutoff falls below 60 Hz; attenuation is calculated only in that branch, without an entered rejection target.

RC Filter Calculator

Use resistance and capacitance to estimate the cutoff, then check that the desired signal can pass.

TipGuided Lab: RC Low-Pass Filter

Try it yourself! Use the RC filter calculator above to trade off noise rejection against response time. The goal is not “maximum filtering”; the goal is “enough filtering while still seeing the real sensor event.”

1. Baseline

Start with R = 10 kΩ and C = 100 nF. Notice the cutoff is about 159 Hz.

2. More filtering

Increase C to 1 µF. Noise rejection improves, but the sensor response becomes slower.

3. Too much filtering

Push R or C very high and ask whether a fast event would be delayed or missed.

Design question: for a sensor that changes every few seconds, what cutoff removes motor noise without hiding the real change?

Note

Learning Points.

Observe:

  • Low-Pass Filtering: High frequencies (noise) blocked, low frequencies (signal) pass through.
  • Time Constant τ: Larger R or C = slower response, more filtering.
  • Exponential Response: Capacitor charges/discharges exponentially.
  • Rise Time: A first-order step rises from 10% to 90% in about 2.2τ; about 5τ reaches within 1% of the final value.

Sensor Applications:

  • Noise Filtering: Remove electrical noise from analog sensor readings.
  • Debouncing: Smooth mechanical switch bounces.
  • Anti-Aliasing: Filter high frequencies before ADC sampling.
  • Smoothing: Reduce jitter in sensor measurements.

Example: A 10 kOhm resistor with a 100 nF capacitor gives a time constant of 1 ms and a cutoff of about 159 Hz. That removes faster electrical noise while preserving slower sensor changes.

Back to the chapter