Try It: I2C Address Conflict Checker

Try It: I2C Address Conflict Checker

animation
sensors
Try Keep Sensor 1 as BMP280 and Sensor 2 as BME280, then change Sensor 4 from DS3231 RTC to (none).
Observe The opening selections produce two conflicting pairs: BMP280 with BME280 at 0x76, and MPU6050 with DS3231 RTC at 0x68.
Explain Sensor 1 and Sensor 2 collide because the first address in each lookup entry is the same; an available second address marks that pair as resolvable.

Technical boundaries. The checker assumes every selected device starts at its first listed address. It evaluates pairs without assigning a globally consistent address plan, and its INA219 and PCA9685 alternate-address lists are only partial.

Try It: I2C Address Conflict Checker

Two devices with the same address can respond together. Check the address plan before joining them to the bus.

Note

Enter the sensors in your design to check for I2C address conflicts. The tool identifies collisions and suggests resolution strategies.

The INA219 supports all 16 I2C addresses from 0x40 through 0x4F. This checker lists only four representative addresses (0x40, 0x41, 0x44, and 0x45), so its alternate-address list is incomplete.

Back to the chapter