Challenge 2: EEPROM Calibration Storage

Challenge 2: EEPROM Calibration Storage

animation
sensing
calibration

Challenge 2: EEPROM Calibration Storage

A device that loses its coefficients on restart cannot use its last fit. Store the gain and offset, then check that the stored values are valid before using them.

Note

Goal: Persist calibration coefficients so they survive power cycles.

Tasks:

Add the EEPROM library and save the calculated calibration. Load it at startup and check a magic number to detect an uncalibrated state. Add a ‘w’ command to write the calibration and an ‘e’ command to erase it.

#include <EEPROM.h>

// EEPROM addresses
const int EEPROM_MAGIC_ADDR = 0;
const int EEPROM_GAIN_ADDR = 4;
const int EEPROM_OFFSET_ADDR = 8;
const int EEPROM_MAGIC_VALUE = 0xCAFE;

void saveCalibrationToEEPROM() {
    EEPROM.begin(64);
    EEPROM.put(EEPROM_MAGIC_ADDR, EEPROM_MAGIC_VALUE);
    EEPROM.put(EEPROM_GAIN_ADDR, calGain);
    EEPROM.put(EEPROM_OFFSET_ADDR, calOffset);
    EEPROM.commit();
    Serial.println("Calibration saved to EEPROM!");
}

void loadCalibrationFromEEPROM() {
    EEPROM.begin(64);
    int magic;
    EEPROM.get(EEPROM_MAGIC_ADDR, magic);

    if (magic == EEPROM_MAGIC_VALUE) {
        EEPROM.get(EEPROM_GAIN_ADDR, calGain);
        EEPROM.get(EEPROM_OFFSET_ADDR, calOffset);
        Serial.println("Calibration loaded from EEPROM");
    } else {
        Serial.println("No valid calibration found, using defaults");
        calGain = 1.0;
        calOffset = 0.0;
    }
}

Back to the chapter