Step 2: Test a Five-Node Route

Step 2: Test a Five-Node Route

animation
z-wave
protocols

Step 2: Test a Five-Node Route

Create a five-node scenario with one controller, two mains-powered repeaters, one sleeping sensor, and one critical endpoint. Run three paper or software passes:

  • In a local Python route model, set one transmit-plus-ack step to the chapter’s stated 40 ms model assumption.
  • The run printed direct=40 ms, two-repeaters=120 ms, and four-repeaters=200 ms before retries.
  • With one failed attempt plus two retries, it printed 3 failed route attempts before choosing a two-repeater alternate at 120 ms baseline.
  • Mark a sleeping sensor used as a repeater REJECT; the local model did so, but no controller or radio hardware was run.
  • For each pass below, retain the route, failed assertion, and controller diagnostic still needed on your own hardware.
  • On your own hardware, look for an acknowledgement failure followed by retransmission, an alternate route, or an Explorer Frame after known routes fail, as described in the cited Silicon Labs networking guide.
  1. Baseline route with all repeaters available.
  2. One repeater removed.
  3. Sleeping sensor incorrectly marked as a repeater.

For each pass, write the route result, the assertion outcome, and the hardware evidence still required. The final answer should not be “works” or “fails”; it should be a short evidence packet that another reviewer can use.

Back to the chapter