Performance Challenges

Performance Challenges

animation
networking
performance

Challenge Exercises

TipMeasure Real Wi-Fi Performance

Modify the code to measure actual network performance instead of simulation:

  1. Connect the ESP32 to your Wi-Fi network
  2. Send HTTP requests to a known server (like httpbin.org)
  3. Measure actual round-trip time using millis()
  4. Compare simulated results to real-world measurements

Hint: Use WiFi.h and HTTPClient.h libraries. Real measurements can be more or less variable than a chosen simulation profile; repeat under stated load and path conditions.

TipAdd Adaptive Bitrate Simulation

Implement adaptive transmission similar to video streaming:

  1. Monitor current network conditions (latency, loss rate)
  2. If conditions degrade, reduce payload size (lower “quality”)
  3. If conditions improve, increase payload size
  4. Display quality level changes on Serial Monitor

Hint: Create quality levels like “High (500 bytes)”, “Medium (200 bytes)”, “Low (50 bytes)” and switch based on measured performance.

TipImplement Congestion Control

Add TCP-like congestion control to the simulator:

  1. Implement slow start: Begin with small transmission rate
  2. Implement congestion avoidance: Gradually increase rate
  3. On packet loss: Cut rate in half (multiplicative decrease)
  4. Visualize the congestion window (CWND) changes

Hint: Research TCP Reno’s AIMD (Additive Increase Multiplicative Decrease) algorithm.

TipChallenge 4: Multi-Sensor Competition

Simulate multiple IoT sensors competing for network resources:

  1. Create 5 virtual sensors, each trying to send data
  2. Implement a simple TDMA (time division) scheduler
  3. Compare performance with and without scheduling
  4. Show whether fair queuing improves per-sensor delay and access under the chosen load; total throughput may stay the same or fall slightly from scheduling overhead

Hint: Use an array of sensor structures and cycle through them with different scheduling algorithms.

Back to the chapter