Optional BME280 Lab Workflow

Optional BME280 Lab Workflow

Stage What to do What success looks like
Confirm address Scan for 0x76 or 0x77 The address matches the sensor’s SDO pin setting.
Initialize driver Start the BME280 library with the detected address Startup message reports the sensor is ready.
Read slowly Request temperature, humidity, and pressure every 2 seconds Values change smoothly and remain physically plausible.
Compare environment Warm the sensor with your hand or move it near airflow Temperature/humidity respond in the expected direction.
Diagnose failure If readings fail, inspect bus and address first Most failures are wrong address, missing pull-ups, or swapped wires.
Symptom Likely cause Fix
“Sensor not found” Wrong address or wiring Try 0x76 and 0x77; recheck SDA/SCL and power.
Readings freeze Bus lockup or clock stretching timeout Slow the bus, shorten wires, and add bus recovery.
Values are unrealistic Wrong sensor/library mode Verify the exact BME280/BMP280 module and driver settings.

Back to the chapter