Sampling Rate Design Calculator

Sampling Rate Design Calculator

animation
electronics
Try Keep Highest Signal Frequency (Hz) at 500 and compare Oversampling Factor at 2.5x with 4x.
Observe The opening 2.5x setting recommends 1,250 Hz against a 1,000 Hz Nyquist minimum. With 12 bits, 60 seconds and one channel, storage is 146.5 KB.
Explain Oversampling Factor multiplies the highest frequency; storage then multiplies that rate by bytes per sample, duration and channel count.

Technical boundaries. Storage assumes whole bytes per sample, rounded up, without file headers or compression. The filter cutoff is simply the highest signal frequency, and estimated current follows the fixed rule 2 + 0.001 times sampling rate in mA.

Sampling Rate Design Calculator

NoteNyquist Rate Calculator

Use this calculator to determine the required sampling rate, storage needs, and estimated power draw for your IoT sensor design. Enter your signal parameters and the calculator will apply the Nyquist theorem with practical engineering margins.

How to use: Enter your signal’s highest frequency component, then choose a sampling margin for the anti-alias filter and timing requirements before setting ADC resolution, recording duration, and channel count. The calculator outputs the Nyquist minimum, practical recommended rate, required anti-aliasing filter cutoff, storage budget, data throughput rate, and estimated ESP32 ADC current draw.

Back to the chapter