viewof ohm_solve_for = Inputs.select(["Voltage (V)", "Current (I)", "Resistance (R)"], {value: "Resistance (R)", label: "Solve for:"})
viewof ohm_v = Inputs.range([0, 48], {value: 3.3, step: 0.1, label: "Voltage (V)"})
viewof ohm_i_ma = Inputs.range([0.1, 5000], {value: 20, step: 0.1, label: "Current (mA)"})
viewof ohm_r = Inputs.range([1, 100000], {value: 165, step: 1, label: "Resistance (Ω)"})Interactive Electronics Calculators / Worked Example: Using the Ohm’s Law Calculator
Interactive Electronics Calculators / Worked Example: Using the Ohm’s Law Calculator
animation
electronics
Try Leave Solve for: on Resistance (R), with Voltage (V) at 3.3 and Current (mA) at 20, then choose Current (I).
Observe The opening Resistance (R) calculation shows 165.0 Ω and 66.0 mW. Choose Current (I) to watch the result change to current.
Explain Solve for: selects a rearrangement of voltage equals current times resistance; power is the resulting voltage times current.
Technical boundaries. The tool assumes a purely resistive relationship and converts milliamps to amps before calculation. Only the two inputs needed for the selected unknown affect that result; thermal changes and part ratings are not modelled.
Interactive Electronics Calculators
Voltage is the difference that drives current through a path. Resistance opposes that current. For a resistor, Ohm’s law relates them: voltage equals current times resistance. The tools below use that relationship to check a part choice; measured conditions and device limits still matter.
TipWorked Example: Using the Ohm’s Law Calculator
Use the supply and LED voltage to find the voltage across the resistor. Choose a current, calculate the resistance, and check the result against the part ratings.
Common IoT Applications:
1. LED Current Limiting:
- Supply voltage - LED forward voltage = voltage across resistor
- R = V_resistor / I_desired
- Always use next higher standard resistor value
2. Pull-up/Pull-down Resistors:
- Typical values: 10kΩ (low power), 4.7kΩ (faster switching), 1kΩ (strong pull)
- A larger pull resistance reduces current while the line is asserted.
- Response also depends on line capacitance, leakage, and receiver thresholds; check the required timing.
3. Power Budget:
- Calculate power for each component: P = V × I
- Sum total power consumption
- Verify power supply can handle total current
- Check individual component power ratings (¼W, ½W, 1W resistors)
Standard Resistor Values (E12 series): 10, 12, 15, 18, 22, 27, 33, 39, 47, 56, 68, 82 (and multiples: ×10, ×100, ×1k, ×10k, ×100k)