MOSFET Power Dissipation Calculator

MOSFET Power Dissipation Calculator

animation
electronics
Try Leave Load current (A) at 0.5 and Rds(on) (ohms) at 0.022. Raise PWM frequency (Hz) from 1000 to compare the two displayed power terms.
Observe The defaults give 5.5 mW conduction loss and 0.21 mW in the row labelled Switching loss. Their displayed total is 5.7 mW.
Explain Conduction loss squares Load current (A) and multiplies it by Rds(on) (ohms). The other term multiplies gate charge, Gate voltage Vgs (V) and PWM frequency (Hz), which estimates gate-drive power.

Technical boundaries. The calculation assumes constant on-resistance and adds I²R to Qg × Vgs × frequency. The total omits switching-transition loss; advice at 0.1 W and 0.5 W does not use thermal resistance or ambient temperature.

MOSFET Power Dissipation Calculator

The gate charge Qg is the charge needed to drive the MOSFET gate. Vgs is the voltage between gate and source. This calculator is a limited exercise, not a heatsink selector. Its Qg × Vgs × frequency term estimates gate-drive power, not loss in the MOSFET during switching transitions. Its displayed total omits transition losses, and its heatsink advice ignores package, board, ambient temperature, and thermal resistance. Measure or calculate those separately before choosing a package or heatsink.

Back to the chapter