Load Experience with PWM/DAC

Load Experience with PWM/DAC

animation
electronics
Try Keep Output method to simulate on PWM + RC filter with PWM duty cycle (%) at 50, then increase RC filter capacitance (uF).
Observe At the opening 5 V supply, PWM average is 2.50 V and RC cutoff is 72.3 Hz.
Explain PWM duty cycle (%) sets the mean as supply times duty fraction; the filter moves each plotted value toward the current pulse voltage.

Technical boundaries. The waveform assumes a first-order RC update across 260 points covering three PWM periods, starting at the mean voltage. Ripple is measured over the last two thirds; motor speed is a duty-based proxy and True DAC ripple is fixed at zero.

TipLoad Experience with PWM/DAC

The controls change duty, frequency, supply, and filter values. Watch how those choices change the modeled waveform; check the actual circuit with its load before building a design.

What to try:

  • Set duty cycle to 25%, 50%, and 75%; notice how average voltage and LED brightness change.
  • Switch to PWM + RC filter, then increase capacitance; the output gets smoother but responds more slowly.
  • Lower PWM frequency below the filter cutoff; the ripple warning should appear.
  • Switch to True DAC and compare the stable blue voltage level with the PWM pulses.

Back to the chapter