Try It: ESP32 DAC Output Simulation

Try It: ESP32 DAC Output Simulation

animation
electronics

For the DAC sweep code referenced as “the lab below”, open Lab 1: DAC Output with ESP32.

TipTry It: ESP32 DAC Output Simulation

If you want a hardware-style simulator after using the in-page simulator, launch Wokwi and test the DAC example directly in a full browser tab:

Open Wokwi ESP32 Workspace Open Wokwi ESP32 Guide

Challenge: Generate a smooth voltage sweep from 0V to 3.3V

Steps:

  1. Open the ESP32 workspace and create a new blank project
  2. Paste the DAC sweep code from the lab below into the sketch
  3. Add code in the loop: dacWrite(25, value) where value sweeps from 0 to 255
  4. Connect a high-impedance simulated voltmeter between GPIO25 and ground, with no LED load.
  5. Use Vout≈value255×3.3VV_{out} \approx \frac{value}{255} \times 3.3V as an ideal endpoint-scaled prediction.
  6. For value 128, predict about 1.66 V and compare with the simulated reading.
  7. Compare the stepped DAC output with PWM switching. A real DAC needs measurement and load-limit checks.

What to observe: A DAC supplies a voltage level for each code. Check real noise, error, and load limits; filtered PWM may also suit an application if it meets the same requirements.

Back to the chapter