Try It Yourself

Try It Yourself

animation
electronics

Try It Yourself

You have been reading numbers all chapter – 0.7 V silicon, 0.3 V Schottky, color-dependent LED drops. Now put a multimeter on real parts and watch those same numbers appear on your bench.

Challenge: Measure Diode Forward Voltage Drop

Objective: Verify diode forward voltage varies by type and current, understanding real vs ideal behavior.

Materials Needed:

  • Multimeter with diode test mode
  • 1N4007 silicon diode
  • 1N5819 Schottky diode
  • LED (any color)
  • 9V battery, 1kΩ resistor, breadboard

Steps:

  1. Use multimeter diode mode to measure forward voltage of each diode (no circuit needed)
  2. Build circuit: 9V battery → 1kΩ resistor → diode → ground
  3. Measure voltage across diode with multimeter
  4. Calculate current: I = (9V - Vdiode) / 1kΩ
  5. Compare measured Vf at load current vs diode test mode

Solution Example:

  • 1N4007 diode test: 0.65V (low current ~1mA)
  • 1N4007 in circuit at 8mA: 0.72V (increases with current)
  • 1N5819 Schottky: 0.28V (lower Vf, better efficiency)
  • Red LED: 1.8V (forward voltage depends on semiconductor bandgap)
  • Blue LED: 3.1V (wider bandgap = higher voltage)

Expected Observation: Forward voltage rises with current through the junction’s current-voltage relationship; series resistance contributes more at higher current. A 0.4 V saving for a Schottky versus silicon is an example, not a fixed difference. Compare data sheets at the actual current and temperature. LED drop also depends on material and color.

Back to the chapter