Lab 2: PWM LED Dimming with Arduino

Lab 2: PWM LED Dimming with Arduino

animation
electronics

Lab 2: PWM LED Dimming with Arduino

PWM changes the LED on-time. As the duty setting rises, observe the light through the current-limiting resistor and compare perceived brightness with the setting.

Materials (or simulate in TinkerCAD / Wokwi): - Arduino Uno - 1x LED (any color) - 1x 220 ohm resistor - Jumper wires

Circuit:

  • LED anode → 220 ohm resistor → Pin 9 (PWM)
  • LED cathode → GND

Arduino PWM dimming code

The loop raises and lowers the PWM duty setting in steps. With a suitable resistor and LED, observe how the apparent brightness changes as the on-time changes.

const int ledPin = 9;  // PWM pin

void setup() {
    pinMode(ledPin, OUTPUT);
    Serial.begin(9600);
}

void loop() {
    // Sweep brightness up
    for (int duty = 0; duty <= 255; duty += 5) {
        analogWrite(ledPin, duty);

        float dutyCyclePct = (duty / 255.0) * 100.0;
        float avgVoltage = (duty / 255.0) * 5.0;

        Serial.print("PWM: ");
        Serial.print(duty);
        Serial.print(" | Duty: ");
        Serial.print(dutyCyclePct, 1);
        Serial.print("% | V_avg: ");
        Serial.print(avgVoltage, 2);
        Serial.println("V");

        delay(50);
    }

    // Sweep brightness down
    for (int duty = 255; duty >= 0; duty -= 5) {
        analogWrite(ledPin, duty);
        delay(50);
    }
}

Expected Learning:

Predict how the on-time changes with each duty setting. Observe the LED through its current-limiting resistor; perceived brightness need not change linearly with duty cycle.

Back to the chapter