Edge vs Cloud Latency Explorer

Edge vs Cloud Latency Explorer

animation
edge
analytics-ml

Edge vs Cloud Latency Explorer

Use this explorer to compare end-to-end latency for different placement options (device-only, edge gateway, cloud) under configurable network conditions. This helps you make informed decisions about where to process data in your IoT architecture.

Latency Calculator

Tip

Interactive Animation: This visualization is under development.

How to Use This Explorer

Note

Network Condition Presets:

  • LAN/Wi-Fi: Edge latency 1-5 ms, Cloud latency 10-30 ms
  • Cellular (4G/5G): Edge latency 10-20 ms, Cloud latency 50-150 ms
  • Satellite/Rural: Edge latency 20-50 ms, Cloud latency 200-600 ms

Real-World Scenarios:

Use Case Max Latency Recommended Architecture
Factory emergency shutdown 10-20 ms Device-local processing
Smart home automation 50-100 ms Edge gateway
Environmental monitoring 1000 ms+ Cloud processing acceptable
Autonomous vehicle control 1-5 ms Device-local with edge backup
Smart building HVAC 500-1000 ms Edge or cloud (either works)

Factory emergency shutdown

Max latency: 10-20 ms

Recommended architecture: Device-local processing

Smart home automation

Max latency: 50-100 ms

Recommended architecture: Edge gateway

Environmental monitoring

Max latency: 1000 ms+

Recommended architecture: Cloud processing acceptable

Autonomous vehicle control

Max latency: 1-5 ms

Recommended architecture: Device-local with edge backup

Smart building HVAC

Read the Smart building HVAC material as a decision path rather than as isolated entries. First identify the operating condition in each entry and keep its units, timing, source, and assumed system state attached to it. Next compare the entries at the point where responsibility changes between device, gateway, network, analytic service, and operator; that hand-off is where apparently similar choices often produce different outcomes. Then follow the failure case: ask what becomes stale, delayed, unavailable, or unsafe, who detects it, and what evidence permits recovery. Finally connect the result to the chapter’s running design record by naming the selected behavior, the rejected alternative, the measurement that justifies the choice, and the condition that forces a recheck. That order turns the examples or comparison into an auditable engineering argument.

Max latency: 500-1000 ms

Recommended architecture: Edge or cloud (either works)

Key Insights:

  • WAN latency can dominate: The cloud round-trip includes the outward and return paths and may exceed local edge-processing time.
  • Safety-critical systems: Must process locally – network failures cannot prevent emergency responses
  • Hybrid is best: Edge for time-critical decisions, cloud for analytics and ML training
  • Cost vs. Latency trade-off: Cloud processing may be cheaper but slower; edge requires hardware investment

Try These Experiments:

  1. Set cloud latency to 200 ms (satellite link) – see how edge becomes essential
  2. Set latency requirement to 20 ms – observe that only local processing works
  3. Compare bandwidth costs: In this exercise, assume local aggregation reduces data transmission by 90%.

Technical boundaries. The comparison uses the listed network condition presets and scenario latency requirements. The bandwidth cost experiment assumes local aggregation reduces data transmission by 90%, and the interactive visualization is under development.

Back to the chapter