NeoPixel Strip Power Calculator

NeoPixel Strip Power Calculator

animation
actuators
visual
audio
Try Start with Number of LEDs at 60 and Brightness (%) at 100, then change Color Mode from Full White (RGB) to Single Color.
Observe Full white starts at 3.60 A and 18.00 W, with a recommended supply of 4.32 A. Watch those totals fall when you select a single colour.
Explain Color Mode sets the current per LED, which is multiplied by Brightness (%) and Number of LEDs to obtain total current.

Technical boundaries. The model assumes 60, 20 or 30 mA per LED at full brightness for the three colour modes. Supply voltage stays at 5 V and the suggested current rating adds 20%; wiring losses are not calculated.

TipNeoPixel Strip Power Calculator

Calculate power requirements for addressable LED strips:

Before accepting the calculator result, inspect the figure to connect per-pixel current to the repeated physical load. WS2812B pixels draw approximately 60 mA at full white and about 20 mA for a single colour, so strip length and credible display state set the supply requirement.

A flexible strip of small square RGB LED modules connected in a row
A WS2812B strip like this is the hardware behind the note above: each pixel draws about 60mA at full white, so a full strip’s current adds up fast enough to need an external supply sized with the recommended 20% safety margin, not USB power. Photo: nabseguf, CC BY-SA 4.0

In the figure, follow the flexible conductors past each repeated RGB pixel. Data is forwarded along the chain, but power current accumulates across all illuminated channels; that is why the calculator adds every pixel and then applies margin rather than treating the data pin or USB connector as the load supply.

Back to the chapter