← Back to the chapter · Next detail →

Technical detail · RFID Integration: Antennas and Event Pipelines

RF margin and self-jamming

10.5 RF Margin and Self-Jamming Are Installed Risks

A monostatic UHF reader transmits and receives at the same time on the same frequency, so it is always listening through its own carrier. It uses a circulator or directional coupler to isolate the strong outgoing transmit path from the faint incoming backscatter, plus receiver cancellation to subtract its own leakage. This self-jamming problem is the reason a tag reply often uses a subcarrier offset from the carrier; otherwise it would be buried under the reader’s own signal.

Encoding is another air-interface choice. Selecting a slower Miller subcarrier and higher M through the reader’s settings can improve tag-reply noise immunity at the cost of data rate. Increasing an LLRP report buffer or changing host transport does not repair an RF reception problem. Conversely, successful on-air reads lost when the host queue fills need queue capacity or draining and inspection of the drop counter.

A simple RF budget explains why an installation can pass on the bench and fail after mounting. Suppose the approved site configuration gives about 35 dBm EIRP at 915 MHz. At 3 m, free-space path loss is approximately 32.44 + 20log10(915) + 20log10(0.003) = 41.2 dB. Before tag orientation and material loss, the incident field is roughly 35 - 41.2 = -6.2 dBm at an isotropic receive point. A tag with several dB of orientation and packaging loss may still power up if its sensitivity budget allows it, but the margin can disappear when the tag is against liquid, metal, or a poorly aligned face.

The return path is harder because passive backscatter is a weak reflection. The reader also needs receiver sensitivity, leakage cancellation, antenna isolation, and a clear enough subcarrier to hear the reply. Moving an antenna 50 cm, adding a metal guard, or swapping a cable can change both forward power at the tag and backscatter received at the reader. Release evidence should therefore include installed-distance tests, antenna-port identity, signal or reader-status fields where available, and the exact ROSpec or vendor-equivalent configuration.

← Back to the chapter · Next detail →