Skip to content

Check: Fusion, Wake Sources and Valid Readings

Knowledge check · self-test

Check: Fusion, Wake Sources and Valid Readings

Review Fusion, Wake Sources and Valid Readings.

Back to the chapter →

Review Fusion, Wake Sources and Valid Readings.

**Question 3:** Why must you configure a wake source BEFORE calling esp_deep_sleep_start()? **Answer:** **Without a configured wake source, the device sleeps forever and cannot recover without a manual power cycle.** Deep sleep disables the CPU and most peripherals. There is no automatic timeout - the device will remain in sleep mode indefinitely (consuming ~10uA) until a wake event occurs. If no wake source is configured, no wake event can ever occur, and the device is effectively bricked until physically reset. Always configure at least one wake source (timer, GPIO interrupt, touchpad, or ULP coprocessor) before entering deep sleep. ::: {.callout-note}

Back to Low-Power Sensors: Duty Cycles and Fusion: Make Sleep and Measurement Reliable