Check: Filtering and pull-up evidence

Knowledge check · self-test
Check: Filtering and pull-up evidence
Filtering choices must preserve the useful signal while reducing unwanted variation; pull-up values must satisfy both signal timing and device current limits. The checkpoint below summarizes the constraints to check for the actual circuit and bus. You now know: - A 10 kOhm resistor with 100 nF gives a 1 ms time constant and about a 159 Hz cutoff. - I2C reliability depends on capacitance, rise time, and sink current. Calculate both resistance limits for the actual bus. - The 400kHz, 100pF example computes 300ns / (0.8473 x 100pF) = 3.5kohm, so 2.2kohm may be suitable if it also meets the sink-current limit.
Filtering choices must preserve the useful signal while reducing unwanted variation; pull-up values must satisfy both signal timing and device current limits. The checkpoint below summarizes the constraints to check for the actual circuit and bus. You now know: - A 10 kOhm resistor with 100 nF gives a 1 ms time constant and about a 159 Hz cutoff. - I2C reliability depends on capacitance, rise time, and sink current. Calculate both resistance limits for the actual bus. - The 400kHz, 100pF example computes 300ns / (0.8473 x 100pF) = 3.5kohm, so 2.2kohm may be suitable if it also meets the sink-current limit.
Back to Sensor Circuits: Dividers and Filtering: Keep the Signal While Reducing Noise