Skip to content

Check: Control, load and turn-off paths

Knowledge check · self-test

Check: Control, load and turn-off paths

Trace the control signal to the switch, then follow the separate current path through the load and back to the supply.

Back to the chapter →

Trace the control signal to the switch, then follow the separate current path through the load and back to the supply.

The driver charges the gate, the MOSFET carries motor current, and the clamp provides a path as that current decays. Each path has its own voltage, current, and heat limits:

  • A 3.3V ESP32 GPIO pin should command the switch, not power a 12V motor directly.
  • The MOSFET example checks voltage rating, current rating, gate drive, Rds(on), and heat before calling the design safe.
  • The driver and 10 ohm gate resistor control gate charge; pull-downs set a defined off state, and the selected clamp gives motor current a turn-off path.

Back to Electronics for IoT: Power and Switching: Verify the Parts and Current Paths Together