Check: Loading and changing loads

Knowledge check · self-test
Check: Loading and changing loads
Return to the LED review above: 3.3 V supply minus a 2.0 V LED drop leaves 1.3 V across the 260 Ω resistor. At 5 mA it dissipates 6.5 mW. Now change one condition at a time to see how current or heat responds. Use the same LED path to test two changes. Keep the voltage across the resistor clear in each case before computing current or power. Predict: The resistor rises to 330 Ω with the same 1.3 V across it. What current follows? Check: $1.3/330=0.00394\ \text$, or about 3.94 mA. Predict: The LED is shorted, leaving 3.3 V across 260 Ω. Does resistor heat rise? Check: Yes. Power becomes $3.3^2/260=0.0419\ \text$, about 41.9 mW. These prediction checks extend the GPIO LED review: name the path and voltage, calculate current and power, and compare both with component ratings. On the built circuit, measure LED current and resistor heat. For a motor supply, also measure voltage during startup because extra current can cause sag or reset the controller; check protection against the fault you expect.
Return to the LED review above: 3.3 V supply minus a 2.0 V LED drop leaves 1.3 V across the 260 Ω resistor. At 5 mA it dissipates 6.5 mW. Now change one condition at a time to see how current or heat responds. Use the same LED path to test two changes. Keep the voltage across the resistor clear in each case before computing current or power. Predict: The resistor rises to 330 Ω with the same 1.3 V across it. What current follows? Check: $1.3/330=0.00394\ \text$, or about 3.94 mA. Predict: The LED is shorted, leaving 3.3 V across 260 Ω. Does resistor heat rise? Check: Yes. Power becomes $3.3^2/260=0.0419\ \text$, about 41.9 mW. These prediction checks extend the GPIO LED review: name the path and voltage, calculate current and power, and compare both with component ratings. On the built circuit, measure LED current and resistor heat. For a motor supply, also measure voltage during startup because extra current can cause sag or reset the controller; check protection against the fault you expect.
Back to Ohm's Law and Power: Close the Review with Measurements