Skip to content

Rail and loop checks

Knowledge check · self-test

Rail and loop checks

The shared rail must supply the sum of its branches. Even if it can supply that current, the regulator also needs enough input voltage to maintain the rail. In the example, the assumed dropout leaves too little headroom as the cell discharges. - The shared 3.3V rail example totals 92.4 mA before the separate 5V heater load. - The LED loop needs a 120 Ohm resistor for a 10 mA target from a 3.3V rail with a 2.1V LED drop. - With an assumed 1.0 V dropout, the target needs 4.3 V input. Verify the actual regulator at the load and temperature. For a resistive branch, divide the voltage across it by its resistance to find its current. Add branch currents at a shared node, then check the voltage drops around the loop.

Back to the chapter →

The shared rail must supply the sum of its branches. Even if it can supply that current, the regulator also needs enough input voltage to maintain the rail. In the example, the assumed dropout leaves too little headroom as the cell discharges. - The shared 3.3V rail example totals 92.4 mA before the separate 5V heater load. - The LED loop needs a 120 Ohm resistor for a 10 mA target from a 3.3V rail with a 2.1V LED drop. - With an assumed 1.0 V dropout, the target needs 4.3 V input. Verify the actual regulator at the load and temperature. For a resistive branch, divide the voltage across it by its resistance to find its current. Add branch currents at a shared node, then check the voltage drops around the loop.

Back to IoT Electricity: Kirchhoff Analysis and Diagnostics: Check the regulator through discharge