Check: Sampling and sensor fit

Knowledge check · self-test
Check: Sampling and sensor fit
Checkpoint: Sampling and Sensor Fit. Sampling must preserve the signal band after the filter has removed unwanted higher frequencies. A distance pulse is a timing problem, while a soil probe needs voltage range and noise checks. You now know: A 3.4 kHz band needs a rate above 6.8 kHz and an anti-alias filter; 8 kHz gives some margin. A 100 Hz retained band needs a rate above 200 Hz; 500–1000 Hz can leave room for a filter transition. In the soil example, 64-sample averaging could improve nominal code spacing if ENOB is measured to increase; ultrasonic distance needs timer capture and separate accuracy validation. Sampling must preserve the signal band after the filter has removed unwanted higher frequencies. A distance pulse is a timing problem, while a soil probe needs voltage range and noise checks.
Checkpoint: Sampling and Sensor Fit. Sampling must preserve the signal band after the filter has removed unwanted higher frequencies. A distance pulse is a timing problem, while a soil probe needs voltage range and noise checks. You now know: A 3.4 kHz band needs a rate above 6.8 kHz and an anti-alias filter; 8 kHz gives some margin. A 100 Hz retained band needs a rate above 200 Hz; 500–1000 Hz can leave room for a filter transition. In the soil example, 64-sample averaging could improve nominal code spacing if ENOB is measured to increase; ultrasonic distance needs timer capture and separate accuracy validation. Sampling must preserve the signal band after the filter has removed unwanted higher frequencies. A distance pulse is a timing problem, while a soil probe needs voltage range and noise checks.
The sampling rate must be high enough for the signal band, and a filter must limit frequencies that would alias. Use the highest signal frequency as the starting point.
Back to ADC and DAC: Conversion Calculations: Sampling and sensor fit