Skip to content

Check: Framework Objects

Knowledge check · self-test

Check: Framework Objects

Framework objects and the discovery-to-monitoring loop.

Back to the chapter →

Framework objects and the discovery-to-monitoring loop.

Name who sends the note, who must receive it, and how late is too late. Mark which nodes can move or lose power. Choose one simple route rule. Then test a clear break: block one link, remove one relay, or drain one node. Record delivery, delay, retries, energy, and the path used after the break. A route that works once is only a demo. A route that leaves a review record can support a decision. There is no free choice. Extra paths can aid recovery, but they add traffic and state. A weak radio reading can warn of risk, but it is not distance or proof of a good link. This first pass does not size a fleet or secure every peer. For an ad hoc factory network, tune links, routes, and a factory pilot; check data structures, path methods, attack gaps, and scale limits before accepting the result. Make a small field card for the first trial. Give every node a short name. Mark its power source and normal place. Mark the one service it must support. Send the same note many times. Move one node. Block one path. Turn one relay off. Write down what changed and when. Count success and failure with the same total. Do not tune from one good run. Look for a repeat pattern. A weak link may work when the air is quiet. A strong link may still fail when a queue is full. A short path may use a weak node. A longer path may last longer. Keep route and service results side by side. End the trial with a go, change, or stop choice. Name the open risk. Name the owner. Name the next test. If a node, place, load, or rule changes, reopen the choice. That simple closeout is part of production work.

Back to Ad-Hoc Deployment Framework: Checkpoint: Framework Objects