Check: Driver Choice and Motion Budget

Knowledge check · self-test
Check: Driver Choice and Motion Budget
You now know: - A 28BYJ-48 uses 2048 nominal full steps or 4096 nominal half-steps per output revolution at a 64:1 gearbox ratio; calibrate the actual motor. - ULN2003-style boards expose the coil sequence; A4988 and DRV8825 boards hide it behind STEP, DIR, and current-limit settings. - A NEMA 17 at 1/16 microstepping changes a 200-step revolution into 3200 commanded microsteps, but the current limit and supply voltage still set the usable torque. You now know: - The worked Z-axis example needs 25 revolutions, or 80,000 microsteps, to move 200 mm with an 8 mm lead screw at 1/16 microstepping. - The chapter’s 2 kg load, 40% screw efficiency, and 2× design margin give 12.5 N cm; check the chosen motor’s torque-speed curve at the required travel speed. - The 1,000 steps/s and 500 steps/s^2 profile gives 82 seconds for the 200 mm move, so travel time is part of the actuator evidence.
You now know: - A 28BYJ-48 uses 2048 nominal full steps or 4096 nominal half-steps per output revolution at a 64:1 gearbox ratio; calibrate the actual motor. - ULN2003-style boards expose the coil sequence; A4988 and DRV8825 boards hide it behind STEP, DIR, and current-limit settings. - A NEMA 17 at 1/16 microstepping changes a 200-step revolution into 3200 commanded microsteps, but the current limit and supply voltage still set the usable torque. You now know: - The worked Z-axis example needs 25 revolutions, or 80,000 microsteps, to move 200 mm with an 8 mm lead screw at 1/16 microstepping. - The chapter’s 2 kg load, 40% screw efficiency, and 2× design margin give 12.5 N cm; check the chosen motor’s torque-speed curve at the required travel speed. - The 1,000 steps/s and 500 steps/s^2 profile gives 82 seconds for the 200 mm move, so travel time is part of the actuator evidence.